Juniper-systems Allegro DOS Manual Uživatelský manuál stáhnout pdf (Strana 183)

MS-DOS Page 5-23

Terminal Emulation Program

The Terminal Emulation program is used to test communication

protocol settings and hardware connections between the Allegro and

another device such as a bar code wand, GPS receiver or another

computer.

Connect the device to the Allegro and set up the communication

parameters.

Press <F10> Util from FileScout to bring up the Utilities menu. Select 1

“Terminal” to execute the Terminal Emulation program. The following

screen appears:

F1 F2 F3 F4 F5

Communication Parameters

In the heading at the top of the screen the default settings for the

communication port, baud rate, data bits, parity, and stop bit are shown.

The communication port, baud rate, and parity can be adjusted if

necessary through the <F2> Params function. The data bits (8) and stop

bit (1) cannot be adjusted.

1 2 ... 178 179 180 181 182 183 184 185 186 187 188 ... 273 274

Žádné komentáře

Juniper-systems Allegro DOS Manual Uživatelský manuál Strana 183