Juniper-systems Mesa User Guide Uživatelský manuál stáhnout pdf (Strana 39)

CAUTION: Restoring the Mesa to its original factory state

permanently erases data saved on the Mesa, any soware you

installed, and any changes you made to the Mesa, including

changes to seings.

1. Reset the Mesa (press and release the power buon

and

choose Reset).

2. As soon as the screen goes blank, press and hold the

+ + buons simultaneously. The rst tick mark on

the screen lights up and the Mesa looks to see if these keys

are being pressed. If they are, the backlight dims and the

boot process stalls until all these keys are released.

3. Release the keys. The backlight returns to normal

brightness and the boot process continues.

Subdued Lighting (Tactical) Mode

There are environments where subdued lighting is desired on

the Mesa. The display backlight, LEDs near the lower buons,

and keypad illumination can be subdued during the startup

process and normal operation.

1. Save open les and close running programs on the Mesa.

Reset the Mesa by pressing and holding the power buon

until the Power Buon menu appears. Choose Reset. The

screen briey turns black as the startup process begins.

2. Simultaneously press the

+ + buons during the

startup process. Continue to press these buons until the

startup progress screen is displayed and the rst tick mark

on the screen lights up (this takes a few seconds).

3. Release the buons. The boot process proceeds normally.

4. The change to subdued lighting during startup takes eect

aer a full reset or power o/on sequence.

To restore the Mesa to default lighting, follow the same steps.

The brightness up

and brightness down buons can be

used at any time to adjust the screen brightness.

Ch 3 Programs and Settings 39

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 111 112

Žádné komentáře

Juniper-systems Mesa User Guide Uživatelský manuál Strana 39